McQuay PDAE Specifikace stáhnout pdf (Strana 21)

Catalog 1301 / Page 21 of 32

Accessories

Internal Drain Kit

Contractor To Drill

Three (3) Holes

To Accept Drain Kit

Square Drain Holes

Neoprene Sponge Gasket

Steel Mounting Plate

See Detail

Note: Use of 6" straight drain tube will require modication of

architectural louver.

Square Drain Holes

Neoprene Sponge Gasket

Steel Mounting Plate

Room

Side

1/2" (13mm) O.D. Drain Tube

Alternate 6" Long,

1/2" O.D. Straight Copper Tube

External Drain Kit

Drain Kits

Drain kits are recommended for the heat pump

units, and may be used on any unit as required.

They eliminate excessive condensate accumulation

which is generated during the heating cycle of the

heat pump.

There are two types of drain kits employed with

the Packaged Terminal equipment; internal drains

and external drains.

Internal Drain

An internal drain is mounted to the bottom of

the wall sleeve prior to installation of the sleeve.

Position this drain on the room side of the sleeve

and connect to an internal collection system.

When using a subbase, a 3" × 5" opening is

provided in the subbase for plumbing to the drain.

External Drain

The external drain is attached to the rear of the

wall sleeve, over one of the weep holes. A cap is

provided to seal the remaining weep hole to force

the excessive condensate to one side.

The excess condensate is then evacuated from the

wall sleeve and allowed to drain to the outside of

the building.

Room

Side

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

Komentáře k této Příručce

Žádné komentáře

McQuay PDAE Specifikace Strana 21

Komentáře k této Příručce

Související produkty a manuály pro Split-systém klimatizace McQuay PDAE